90 SEC TOOLTIPS – T16 GIMBAL TENSION

90 SEC TOOLTIPS – T16 GIMBAL TENSION


in this video I will show you how to
modify the jumperin the jumper T16 properly if you are not completely
satisfied with the spring adjustment range the problem is that with the stock
spring guides the spring tension cannot be set to zero so you can set it lose
enough for this modification all you need is a screwdriver and a dremel tool
or something that you can sand our cut plastic with like a sharp knife or a
piece of sanding paper basically what you have to modify is this piece of
plastic right here which is the spring guide you have to cut approximately
two-and-a-half millimeters from the flat end your freedom unit that is 0.1 inch
the hard part is that you have to do it three times you can find these spring guides right
here here so this maybe looks complicated
but all you need is a steady hand and some patience

1 Reply to “90 SEC TOOLTIPS – T16 GIMBAL TENSION”

Leave a Reply

Your email address will not be published. Required fields are marked *